Multidisciplinary Journal of Science and Technology

LAZER VA PLAZMA TEXNOLOGIYALARINING SANOATDAGI ROLI (TAHLIL)

Khasanov Otabek 1.

Tashkent state technical university

Meliboyev Yakhyo2

Tashkent state technical university

Keywords: Inconel 718, lazer yordamida ishlov berish, plazma yordamida ishlov berish, kesish kuchi, yuza sifati, asbobning yeyilishi, qiyin ishlov beriladigan materiallar.

---

Abstract

Mazkur maqolada qiyin ishlov beriladigan materiallarga, xususan Inconel 718 ga lazer (LAM) va plazma (PAM) yordamida issiqlik bilan ishlov berish texnologiyalari yoritilgan. An’anaviy ishlov berish usullari bilan taqqoslaganda, issiqlik bilan kuchaytirilgan ishlov berish kesish kuchlarini kamaytirish, sirt sifatini oshirish va asbob yeyilishini kamaytirish kabi afzalliklarga ega. Tadqiqot natijalari ushbu texnologiyalarni amaliyotda qo‘llash samaradorligini tasdiqlaydi.

---

References

1. Moon S.-H., Lee C.-M. (2018). A study on the machining characteristics using plasma assisted machining of AISI 1045 steel and Inconel 718. IJMS.

2. Liu X. et al. (2024). Influence of tool nose angle on cutting performance in hot machining of Inconel 718. Journal of Engineering and Applied Science.

3. Sousa J.A.G. et al. (2018). A review on the machining of cast irons. Int J Adv Manuf Technol.

4. Kunar S. et al. (2024). Laser-Assisted Machining. In: Innovations in Materials and Manufacturing. Wiley.

5. Venkatesan K. et al. (2016). Parametric modeling and optimization in LAM of Inconel 718. Optics & Laser Technology.

6. Venkatesan K. et al. (2016). Optimisation of machining parameters in laser aided hybrid machining of Inconel 718. IJMMM.

7. Venkatesan K. et al. (2017). Investigation of machinability characteristics and chip morphology in LAM of Inconel 718. IJAMT.